[ПОМИЛКА ПЕРЕКЛАДУ – ОРИГІНАЛЬНИЙ ТЕКСТ]
How to Check the Parallelism of Blade and Base in Your Makita Circular Saw
If you’re using a Makita circular saw, checking the parallelism between the saw blade and the base is crucial for achieving clean, accurate cuts. Misalignment can lead to uneven cuts and can even pose safety risks. Here, we’ll outline a simple procedure to ensure that your blade and base are parallel. What You Need
A hex wrench (usually included with the saw)
A triangular rule or square rule to measure
Some amount of wood or material to perform a test cut
Steps to Check and Adjust Parallelism
Prepare Your Saw:
First, ensure that your saw is unplugged for safety. Make sure all screws and levers on the saw are tightened before starting your adjustments. Inspect the Blade Position:
With the saw off, inspect whether the blade is aligned with the base plate. Compare the distance from the blade to the edge of the base on both sides to check for any visible misalignment. Adjusting the Blade:
If you notice misalignment, slightly loosen the adjustment screw indicated in your user manual. Important: Always keep the lower guard open while you make adjustments.
[ПОМИЛКА ПЕРЕКЛАДУ – ОРИГІНАЛЬНИЙ ТЕКСТ]
Align the Base:
Move the rear of the base back and forth until the distance from the blade to the edge of the base (let’s call these distances A and B) are equal. Use the triangular or square rule to ensure that the blade is 90 degrees to the base for 0-degree cuts, and adjust for 45-degree cuts as necessary. Tighten the Adjustment Screw:
Once aligned, secure the screw tightly to hold the adjustment in place. Testing Your Adjustment:
Plug in your circular saw and perform a test cut on a scrap piece of wood. After completing the cut, check if the cut is straight and meets your standards. Final Check:
Remeasure the distances A and B and make any fine adjustments if necessary. Important Safety Tips
Always plug in your saw only when you are ready to start working. Ensure a proper grip on the saw while making adjustments to avoid any accidents. Wear eye protection to safeguard against dust and debris during operation. Conclusion
Regularly checking and adjusting the parallelism of your Makita circular saw blade and base is essential for maintaining the saw’s performance and safety.
Para que tus cortes salgan perfectos y sin sorpresas, es fundamental que la hoja esté bien alineada. No solo lograrás un acabado más limpio, sino que también reducirás mucho el riesgo de que la herramienta te dé un tirón inesperado. Si ves que el problema persiste, no dudes en echar un vistazo al manual o mejor aún, contacta con un centro de servicio Makita para que te echen una mano profesionalmente. ¡Que disfrutes cortando!